The most expensive thing that can happen to a QR code is finding out it does not scan after thousands of copies have been printed. The good news: you need neither a special device nor technical knowledge to prevent it. The steps below take ten minutes.
Test it on paper, not on screen
Every code looks fine on a screen: the screen makes its own light, the contrast is high and the pixels are flawless. Paper is not like that. Ink spreads, light colours fade and a glossy finish reflects light.
Print the code at the real size it will be printed at and, if possible, on the same paper with an office printer. If it is a business card, at business card size; if it is a poster, the corner carrying the code at real size. Do the test on that printout.
At least three phones, two operating systems
Just because the code scans on your phone does not mean it scans on everyone's. Camera quality, focusing and QR reading software vary from device to device.
- Try it with an iPhone and an Android phone.
- Add at least one old or entry-level phone to the list; it shows difficult conditions best.
- Use the phone's own camera app, not a separate QR app. Most of your customers will scan that way.
Real distance, real light
Scan the code from where the customer will see it: the table card from the chair, the poster from across the street, the packaging from in front of the shelf.
- Distance: The further away the code is scanned from, the bigger it should be. The rough rule is a tenth of the scanning distance. The details are in the print size guide.
- Angle: Try it not only straight on but also from an angle of 30 to 45 degrees.
- Light: Try it in a restaurant's evening dimness, in a shop window's midday sun and in the glare of glossy lamination.
Check the contrast and the quiet zone
Most codes that do not scan have a design problem:
- Keep the code dark and the background light. Inverted colours (a light code on a dark background) do not work on some readers.
- Leave a space at least four modules wide around the code (the quiet zone); do not let a frame or text spill into this area.
- If you added a logo, raise the error correction level.
- Do not stretch the code horizontally or vertically; keep it square.
When you add a logo, the generator automatically raises error correction to the highest level, and if the contrast is low it warns you before you download. If you see no warning, there is most likely no problem on the design side; still, test the print.
Test the destination too
The job is not done just because the code scans. The page that opens must suit your customer too:
- Open the page on mobile data instead of Wi-Fi. How long does it take to load on a slow connection?
- Does it open in the right language, with the right menu or campaign?
- Do the links, phone number and map on the page work?
- If you use a dynamic code, change the destination once, scan again and then roll it back. That way you make sure the redirect works.
A final checklist
- A test print at real size, on the real paper
- Scanned with at least three phones, using the camera app
- Scanned at the real distance, angle and light
- Enough contrast, the quiet zone kept
- The page that opens is fast and correct on mobile data
- If it is a dynamic code, a destination change was tried
If everything is ticked, you can send the file to the printer with peace of mind.